Forums > Product Specific Discussions > L130/L230
Subject: VPN Clients
Prev Next
You are not authorized to post a reply.

Author Messages
pmills4User is Offline

Posts:2
09/02/2008 11:57 AM  

Have anyone gotten the Ncomputing host to work with VPN clients such as Nortel or Cisco?  When one of the terminals tries to run the client, it freezes up the host and I had to manually reboot to get it back to running state.
philcoUser is Offline

Posts:4
09/03/2008 8:49 PM  
just a thought..
Would it be to do split tunneling not being enabled on the VPN client? I know normally with the Cisco client that it sets all traffic to go up the VPN tunnel,, Now remember, technically your HOST is establishing the connection not your l230. So therefore if split tunnelling is not enabled then all host traffic would be routed up the VPN tunnel instead of transmitting the required connection data to the L230's...

If you were to physically sit at the host machine when the connection is established can you use it? Id assume yes and only your l230 sessions freeze because of the data mis-route..

See if you can get the split tunnel setup and see if it works then..
A good test would be to ping one of your l230 device IP's and then connect the VPN from the HOST machine and see if your pings continue succeed. Or try a trace route?

Hope this helps.
Let me know if you need more help,

Cheers.

Phil
You are not authorized to post a reply.
Forums > Product Specific Discussions > L130/L230 > VPN Clients